Shining Light on Magnetic Flux Trapped in a Superconductor


2026-11-16

JPS Hot Topics 6, 045

https://doi.org/10.7566/JPSHT.6.045

© The Physical Society of Japan

This article is on

Vortex Pinning of Ba0.62K0.38BiO3 Investigated by Magneto-Optical Kerr-Effect and Magnetization Measurements (JPSJ Editors' Choice)

Soichiro Yamane, Sota Nakamura, Atsutoshi Ikeda, Dayu Zhai, Siddarth Gorregattu, Xing He, Sudarshan Sharma, Yipeng Cai, Yasutomo J. Uemura, Martin Greven, and Shingo Yonezawa
J. Phys. Soc. Jpn. 95, 114701 (2026) .

The magnetic flux trapped in a superconductor was resolved through ultrasensitive magneto-optical Kerr-effect measurements, thereby providing a basis for using an unconventional superconducting order parameter to distinguish between vortex-induced and magnetic signals.


 Superconductors provide no resistance to electrical current. In type-II superconductors, quantized magnetic flux penetrates the material in the form of vortices; however, vortex motion causes energy loss. Defects can trap or pin these vortices and suppress their motion. Therefore, understanding this pinning phenomenon is essential not only for fundamental physics but also for applications that rely on superconducting materials, such as powerful superconducting electromagnets.

    We used the magneto-optical Kerr effect (MOKE) to investigate vortex pinning in a bismuth oxide superconductor Ba0.62K0.38BiO3 (BKBO). MOKE is a change in the polarization of the reflected light, enabling the optical measurement of magnetic responses. Although MOKE has been widely used to study magnetic materials, it has rarely been used to investigate vortex pinning. Our measurement setup detected the average magnetic response over a region approximately 6 μm in diameter, with Kerr angle sensitivity less than 0.1 μrad.

    Trapping the vortices required cooling a superconducting sample in a magnetic field, named the training field, whereas measurements should be performed at zero field. We developed a movable magnetic shield to suppress the remnant magnetic fields during the measurements while preserving the ability to apply strong fields in advance. The resulting MOKE signals showed dependencies on the temperature and training field, similar to those of magnetization retained by the sample after removing the training field. The responses were successfully analyzed using Bean’s critical-state model, which describes the magnetic flux distributions produced by pinned vortices.

    This optical approach helps address a challenge in the search for “chiral” superconductivity, which is a state accompanied by a tiny magnetic field produced by self-rotating superconducting electron pairs. This field can generate a small MOKE signal without an applied field. However, this study showed that trapped vortices also produced a signal after field removal. Therefore, observing a MOKE signal after field training alone does not prove chiral superconductivity.

    To assess the vortex contribution, the training field was varied in small steps near zero. The BKBO response was approximately linear and continuous, as expected for trapped vortices. Chiral superconductors preferably form domains with opposite circulation directions. Aligning these domains can produce sharper low-field features if they couple sufficiently strongly with the field. This additional feature, indicative of chiral superconductivity, was not detected in BKBO.

    These results establish MOKE as a sensitive optical probe for vortex pinning and provide a practical guide for interpreting MOKE signals in the search for unconventional superconductivity.

(Written by Soichiro Yamane on behalf of all the authors)

Vortex Pinning of Ba0.62K0.38BiO3 Investigated by Magneto-Optical Kerr-Effect and Magnetization Measurements (JPSJ Editors' Choice)

Soichiro Yamane, Sota Nakamura, Atsutoshi Ikeda, Dayu Zhai, Siddarth Gorregattu, Xing He, Sudarshan Sharma, Yipeng Cai, Yasutomo J. Uemura, Martin Greven, and Shingo Yonezawa
J. Phys. Soc. Jpn. 95, 114701 (2026) .

Share this topic

Fields

Related Articles