Shining Light on Magnetic Flux Trapped in a Superconductor
© The Physical Society of Japan
This article is on
Vortex Pinning of Ba0.62K0.38BiO3 Investigated by Magneto-Optical Kerr-Effect and Magnetization Measurements (JPSJ Editors' Choice)
J. Phys. Soc. Jpn.
95,
114701
(2026)
.
The magnetic flux trapped in a superconductor was resolved through ultrasensitive magneto-optical Kerr-effect measurements, thereby providing a basis for using an unconventional superconducting order parameter to distinguish between vortex-induced and magnetic signals.

Superconductors provide no resistance to electrical current. In type-II superconductors, quantized magnetic flux penetrates the material in the form of vortices; however, vortex motion causes energy loss. Defects can trap or pin these vortices and suppress their motion. Therefore, understanding this pinning phenomenon is essential not only for fundamental physics but also for applications that rely on superconducting materials, such as powerful superconducting electromagnets.
We used the magneto-optical Kerr effect (MOKE) to investigate vortex pinning in a bismuth oxide superconductor Ba0.62K0.38BiO3 (BKBO). MOKE is a change in the polarization of the reflected light, enabling the optical measurement of magnetic responses. Although MOKE has been widely used to study magnetic materials, it has rarely been used to investigate vortex pinning. Our measurement setup detected the average magnetic response over a region approximately 6 μm in diameter, with Kerr angle sensitivity less than 0.1 μrad.
Trapping the vortices required cooling a superconducting sample in a magnetic field, named the training field, whereas measurements should be performed at zero field. We developed a movable magnetic shield to suppress the remnant magnetic fields during the measurements while preserving the ability to apply strong fields in advance. The resulting MOKE signals showed dependencies on the temperature and training field, similar to those of magnetization retained by the sample after removing the training field. The responses were successfully analyzed using Bean’s critical-state model, which describes the magnetic flux distributions produced by pinned vortices.
This optical approach helps address a challenge in the search for “chiral” superconductivity, which is a state accompanied by a tiny magnetic field produced by self-rotating superconducting electron pairs. This field can generate a small MOKE signal without an applied field. However, this study showed that trapped vortices also produced a signal after field removal. Therefore, observing a MOKE signal after field training alone does not prove chiral superconductivity.
To assess the vortex contribution, the training field was varied in small steps near zero. The BKBO response was approximately linear and continuous, as expected for trapped vortices. Chiral superconductors preferably form domains with opposite circulation directions. Aligning these domains can produce sharper low-field features if they couple sufficiently strongly with the field. This additional feature, indicative of chiral superconductivity, was not detected in BKBO.
These results establish MOKE as a sensitive optical probe for vortex pinning and provide a practical guide for interpreting MOKE signals in the search for unconventional superconductivity.
(Written by Soichiro Yamane on behalf of all the authors)
Vortex Pinning of Ba0.62K0.38BiO3 Investigated by Magneto-Optical Kerr-Effect and Magnetization Measurements (JPSJ Editors' Choice)
J. Phys. Soc. Jpn.
95,
114701
(2026)
.
Share this topic
Fields
Related Articles
-
Why Does Magnetization Lose its Motion? - Magnetic Damping from Low Temperatures to the Curie Point -
Magnetic properties in condensed matter
2026-11-10
A unified physical outlook of magnetic damping is presented, explaining how the relaxation of magnetization changes from low to Curie temperatures by combining the microscopic spin relaxation and magnetic response.
-
Revealing Electronic Quantum Behavior Masked by Nuclear Heat
Measurement, instrumentation, and techniques
Structure and mechanical and thermal properties in condensed matter
Superconductivity
2026-9-7
The initial slope method is used to reveal intrinsic electronic specific heat by eliminating the overwhelming nuclear contributions during low-temperature calorimetry, opening a new window into quantum materials.
-
Frustrated Sawtooth Yb Chain Yielding Ferromagnetic Order with Reduced Magnetic Moments
Magnetic properties in condensed matter
2026-9-1
The ytterbium-based semiconductor ZnYb2S4 exhibits ferromagnetic order with contracted Yb moments, representing a novel quantum ground state attributed to competing exchange interactions in an effective spin-1/2 frustrated sawtooth chain.
-
Holonomy Reveals Hidden Strain Incompatibilities in Birefringence Imaging
Dielectric, optical, and other properties in condensed matter
Measurement, instrumentation, and techniques
2026-8-17
Holonomy measures how local optical directions fail to return to their original orientation after a closed loop, revealing hidden electromechanical structures in stress-induced ferroelectric SrTiO3.
-
Unlocking a 40-Year-Old Mystery: Full-gap Spin-Triplet Superconductivity Unveiled in UBe13
Magnetic properties in condensed matter
Superconductivity
2026-8-12
Recent precise NMR measurements on the heavy-fermion superconductor UBe13 provided “smoking-gun” evidence for a fully-gapped spin-triplet superconducting state, opening a new chapter in the field.
